Now i have created the nose it is time to move onto making the mouth.

This was not explained in the tutorial, so I had to run this one alone. But really how hard is a mouth to create!! I was hoping that this was not going to be too difficult, and luckily I did not struggle with it that much and it came out pretty good.










I started of by basically using the edge tool selecting the mouth edges, holding shift and pulling out more polygons. Once they had been pulled out using the same method as the face, of selecting the vertex points and welding them together to stop breaking, holes being formed. I then used the create the tool to create more middle polygons to link them all together.










You can see from the image above the direction of the flow from the polygons, (moving outwards and then inwards.)










You can see better from the side angle, how the mouth is positioned and how it lines up with the face. With good definition for both the top and bottom lip.

I had to follow an new line and not use my mouth from the images, because it was too small and would have looked out of proportion with the rest of the face. I used the original shape just on a bit of a larger scale.










Here is the finished mouth after it has been turbo smoothed, it does look like he is pouting quite allot or was that me.

Overall the mouth has come out well next I am going to have to tackle the ear, which i feel is going to be very very tricky.